Solved - in case anyone else has the same problem: On the sub-in board
one of the leads on T1 did not have the paint removed, looked like a
good solder joint until I got the magnifying glass out. Removed the
solder, cleaned off the paint with an Xacto knife, resoldered it, now
working like it should.
Paul W2LE
W2LE wrote:
Just installed my KRX3.
With the sub receiver set to main ant, it sounds like there is no
antenna connected to the sub rcvr. If I switch the sub rcvr to ATU
and connect the antenna to Ant 2 it works fine.
MCU is 2.58 and DSP1 & 2 are 1.94 - just reloaded them. Did I miss
something?
Thanks for any help.
Paul 2LE
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
