I have been using beeswax for years to do this job. A small lump of beeswax will last for pretty much ever in this role. Just stick the point of the screwdriver in it when you need to hold screws to the tip
73 Brendan EI6IZ On Tue, 2008-11-25 at 15:50 -0800, Barbara Maloney wrote: > Hello list members, > I found a trick for holding small screws on the end of the screwdriver > until you can get them into a tight place and started. A small > amount of electrical connector black seal mastic or putty shaped on > the end of the driver takes up the gap enough to hold the screw until > you get it thru the hole and started. Once pulled away, the > putty stays on the screwdriver. > Great for removing screws also. Once in a while the mastic needs > reshaped to the tip of the screwdriver to hold the screw securely. > It beats fingering the tiny screws into close spaces and hoping you > dont drop it before you can get the screwdriver head on it. > I was able to complete assembly on my K3/2170 today and didnt drop a > single screw in the process, thanks to this method. > Mike, AC5P > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com -- Don‘t complain. Nobody will understand. Or care. And certainly don‘t try to fix the situation yourself. It‘s dangerous. Leave it to a highly untrained, unqualified, expendable professional. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
