Hi all,
Wondering if someone can give me some advise please,
I'm driving my xv-144 with a TS850 which according to the ts850 manual has an
output of 0-10dbm so i have chosen the input jumper settings within the xv-144
of 250mW as the lower setting is 1mW and i don't want to over drive the txvr.
I've managed to position the tx coils as per the manual but have stripped the
alignment tool and have been taking to it(the tool) with a knife to try adjust
the slugs with little luck on obtaining a grip on the slugs.
What i'd like to ask about is the voltage measured at TP5 and how critical is
it that the final voltage measured is under 10v as per the manual.To achieve
the 8-10w drive from the xv-144 that i require for my amp i'm measuring just
over 13v at TP5 while adjusting the input attenuator R22.
Wondering if this is ok (?) or if i should persevere with peaking the tx coils
(?)
I'm concerned that if i adjust the jumper setting to 1mW positions that 0-10dbm
will be over driving the xv-144.
Any advice more than welcome and appreciated.
Kind regards
Paul
VK3DDU
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
