S/N 00929 /w FW 2.76, 6.0 kHz filter. Confirmed TX on switch from DATA to
AM when VOX on. Getting typical AM carrier output for about 1 second.
Happens from either front panel mode change or PC control (two different
programs).
Happens from DATA to AM and DATAR to AM (I tried all combinations xx to AM
via PC control).
Also occurs /w 6.0 kHz filter disabled, and on any band.
I THINK I spotted ERR ??? once on VFO B display but vy intermittent - could
(should) not have been END as I was mid-point on all the bands.
This has been around a long time... I went back to FW 1.96 (oldest I have) &
it happens there!
73, Bill N2BC
----- Original Message -----
From: "K2MK" <[email protected]>
To: <[email protected]>; "Elecraft Reflector" <[email protected]>
Sent: Friday, December 26, 2008 8:25 AM
Subject: [Elecraft] Re: Transmit when switching from DATA to AM mode?
Hi Joe:
Consider the possibility of it being the software program you are running
on your PC in DATA mode. Quit the program first then switch to AM.
It's frequently a safe bet to blame the computer for anything that goes
wrong.
73,
Mike K2MK
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
