Good catch, Greg. On my K3, I get the transmit-on-mode-change with
VOX gain > 10. At 10 or less, it doesn't happen. This despite the
fact there is no mic connected.
73
--
Joe
On Dec 26, 2008, at 9:50 AM, Greg wrote:
How high is your VOX setting?
----- Original Message ----- From: "Bill Coleman N2BC" <[email protected]
>
To: "K2MK" <[email protected]>; <[email protected]>; "Elecraft
Reflector" <[email protected]>
Sent: Friday, December 26, 2008 7:08 AM
Subject: Re: [Elecraft] Re: Transmit when switching from DATA to AM
mode?
S/N 00929 /w FW 2.76, 6.0 kHz filter. Confirmed TX on switch from
DATA to
AM when VOX on. Getting typical AM carrier output for about 1
second.
Happens from either front panel mode change or PC control (two
different
programs).
Happens from DATA to AM and DATAR to AM (I tried all combinations
xx to AM
via PC control).
Also occurs /w 6.0 kHz filter disabled, and on any band.
I THINK I spotted ERR ??? once on VFO B display but vy intermittent
- could
(should) not have been END as I was mid-point on all the bands.
This has been around a long time... I went back to FW 1.96 (oldest
I have) &
it happens there!
73, Bill N2BC
----- Original Message ----- From: "K2MK" <[email protected]>
To: <[email protected]>; "Elecraft Reflector" <[email protected]
>
Sent: Friday, December 26, 2008 8:25 AM
Subject: [Elecraft] Re: Transmit when switching from DATA to AM mode?
Hi Joe:
Consider the possibility of it being the software program you are
running
on your PC in DATA mode. Quit the program first then switch to AM.
It's frequently a safe bet to blame the computer for anything that
goes
wrong.
73,
Mike K2MK
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.10.0/1864 - Release Date:
12/25/2008 9:40 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
