I have attempted to do the alignment and Test part 1 on page 43 of the manual.
Controls were set as indicated in the manual. When power turning on the K-2
with S1, there is nothing on the display. It does not read "INFO 201" or
"7100c". Neither will it read "Elecraft" for two seconds. The display always
remains blank. It does pass the relay test when tapping the "Band+" switch.
I also hear the relay click when the "PRE/ATTN" button is tapped.
Current drawn is about 125 ma from a 12.6 volt battery. Any help will be
appreciated.
Thanks.
Larry
[email protected]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
