This issue is also impacted by how well the cover fits over the rcvr board. I had to fiddle with mine a bit and file off some misplaced nubs on the circuit board in order to get the top and bottom sheet metal parts to snap together properly. If the top cover isn't positioned correctly it will hold the screw head too high to mate with the stand-offs. The form, fit, and finish of the rest of the radio is close to perfect but that wrap around cover took a lot of extra care before I finally got mine to fit right.
73/Patrick W7TMT > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Don Wilhelm > Sent: Monday, December 29, 2008 5:13 AM > To: Kenneth Lopez > Cc: [email protected] > Subject: Re: [Elecraft] KRX3 Mounting Problem > > Ken, > > Measure the standoffs mounted on the main board - they should > be 7/8 inch and must have two split lockwashers under them - > a total height above the board not quite an inch. The height > of these standoffs are critical because the 1 1/2 inch screws > only engage the threads for about > 1/8 inch. > > If those standoffs are correct, check all the standoffs that > you mounted in the KRX3 board and the number of lockwashers > between the standoffs and the board - these must be correct > for everything to fit properly. > > 73, > Don W3FPR > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
