yes isolation between ant1 and ant2 is very bad... if I have time I try to change the silgle wires from the rs323 ports to the atu-board to koax wires, maybe this will help a little
73 OE6KYG KX1 244 K2 1331 K3 115 > -----Ursprüngliche Nachricht----- > Von: [email protected] [mailto:elecraft- > [email protected]] Im Auftrag von Dick Roth, KA1OZ > Gesendet: Samstag, 03. Jänner 2009 06:14 > An: Elecraft Reflector > Betreff: [Elecraft] Isolation between Ant 1 and 2?? > > Hello and Happy New Year!! > > Was doing some testing and discovered Ant 1 signal on Ant 2. Ant 1 is > my GAP Titan-DX and Ant 2 is a 100W dummy load. > > I was just reading the mail on 75 meters and switched to Ant 2 to test > power. When key was off, I heard part of the QSO that was going on. > While on my dummy load, I was receiving a station S3, which on Ant 1 was > 20 over S9. > > Has anyone else seen this crosstalk? If so, what is considered > "acceptable"? > > -- > 73, > Dick ka1oz > Middleborough, MA > > Radio: Elecraft K3/100(Kit) SN 859 > Antenna: Titan-DX > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
