Greetings One and All, I just did the calibration for Tx on all bands and all appears fine.
Into both a dummy load and a resonant antenna the external watt meter reads the same on power out as indicated by the K3 when dialing up 25W, 55W, 75W and 100W. There is only a slight drop in the external watt meter when a tone is placed on the K3 on all bands so all appears ok with this K3. I have found a strange anomaly though on 80M DATA A. On MixW set-up as AFSK=FSK I am now getting a normal appearance of Tx on the waterfall plus a birdie further up the band (approx 1.5Kc) however the external watt meter indicates the correct power out, MixW appears to be sending PSK31 BUT I am not getting any answers to my CQ's as I suspect the K3 may not be transmitting on the correct frequency. All other bands are OK, no problems with making contacts. Band width appears normal and filter selection appears correct. Up until very recently, Data modes on 80M were working with MixW, Multi-PSK, HRD-780 etc....nothing is now working on 80M. What have I messed up now?....:-( Any help would be appreciated. Regards, Gary VK4WT K3-100 S/N 679 I just got lost in thought............. It was unfamiliar territory When you think your old..... you are When you think your crook..... you are When you think your bullet proof.....your not
_______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com