By the way we are speaking of K2 #2481 here. OK next question, the xtals that came out were marked 4.91 the ones I put in were marked 4.9136 and the package was marked with 3.7
I bought this rig used and already assembled, it works so well I haven't messed with any adjustments, other than to tweak the CAL FIL settings a bit. After this xtal mod, what part of the alignment should I go through? Any pointers to the page(s) in the mighty fine manual would be appreciated. Also, I have the following 'alignment' pages bookmarked: http://www.elecraft.com/Apps/new_fil_docs/filter_apps.htm http://www.elecraft.com/Apps/new_fil_docs/N0SS_Filter_Adjustment.html http://www.n0ss.net/k2_filters_using_gram_v5r17.pdf http://www.elecraft.com/Apps/new_fil_docs/k2_cw_gram.pdf http://www.elecraft.com/Apps/new_fil_docs/k2_ssb_gram.pdf http://www.qsl.net/w3fpr/download_files/K2_align_manual_rev_E.pdf http://w3fpr.qrpradio.com/n6kr_method.htm http://w3fpr.qrpradio.com/dial_cal.html so I have lots of info at my disposal, in fact, I would say almost to much, if that's possible. Which one of those references do I use and in what order should I use them? P.S. SSB boards new xtal mod been completed. I will have the new main board xtal mod installed by the time I begin to receive answer(s) to my alignment question. NOTE, that's just the K2KSB2XTLS xtal mod, we are not talking about any of the possible mods from http://home.pacbell.net/johngreb/KI6WX.html pages. They have not been done, yet, and may not be done at all, but perhaps that's a subject for another post..... Sam Morgan wrote: > My next project is to install the 14 crystals in the K2KSB2XTLS package > ============== > K2KSB2XTLS > Matched Filter Crystals (14) > For existing K2 and KSB2 combinations. > ============== > > any one have any pointers, gotcha's, or other comments about this mod > they would like to share before I get the iron hot? > -- GB & 73 KA5OAI Sam Morgan http://linuxbasics.org Linux, the lifetime learning experience. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
