Mike Scott wrote: > I installed the second receiver in my K3 and at the same time made the > prescribed audio and line out modifications. > > After checking out the receiver my microphone is now dead using the front > panel. Rear connection works okay. I have been using the front panel > microphone connector without a hitch up until the time I went off line to > make the above modifications. > Did you have to add the resistor on the bottom of the RF board Mike? It is easy to short across one of the tracks and stop the mic audio. I had this problem with the first one I did. Fortunately the second one didn't need the resistor :)
73 Ian -- Ian J Maude, G0VGS SysOp GB7MBC DX Cluster Member RSGB, GQRP, FISTS K2 #4044 |K3 #455 http://www.amateurradiotraining.org _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
