Mike, You have it correct. An identifying mark is used for pin 1 - whether that is a dot or a bar is the component manufacturer's choice. The important thing is that pin 1 is identified by some distinctive mark.
73, Don W3FPR Mike Weir wrote: > Hi all, > Just starting the build of the control board and on page 14 putting in > the resistor packs. I notice that my RP5 is a red resistor pack part > number 103C471T48. It does not have the Dot but a solid line do I > match the solid line with the number one on the board. Just wanted to > make sure before I solder it in place as this pack did not have a dot. > Thanks > Mike > > VE3WDM > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
