Brian Machesney wrote: > I have the TMP cable connected between the KAT3 and the KRX3 input. > The TMP cable from the Aux RF BNC connector is present but insulated, > per the manual instructions, so it is inactive. > > I want the input to the KRX3 to come from the ANT2 connector. What I > need to know is how to set the configuration options to make this > happen. Obviously, the KAT3 and KRX3 CONFIG menu options are set to > something other than "notInst." The only options for the KRX3 are > "Ant-Atu" and "Ant=bnc." So, if I have the KRX3 set to "Ant=bnc" and > the KRX3 input coming from the KAT3, I would expect the KRX3 input to > come from the ANT2 connector - but it doesn't; it still comes from the > ANT1 connector.
Hi Brian, You have the menu entry correct; you need only select AUX for the sub antenna. You can do that two ways: (1) in BSET mode, tap ANT; (2) outside of BSET mode, *hold* RX ANT. The setting is saved per-band, and separately for diversity (AUX) vs. non-diversity (MAIN) on each band. 73, Wayne N6KR --- http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com