You are fine. Fire it up.
73, Steve NN4X On Wed, Jan 21, 2009 at 10:04 PM, Walter V. Gilles <wvgil...@yahoo.com>wrote: > Greetings, > > K3/100 assembly in work. I just did the four resistance checks that verify > the power buses are not shorted to ground. All R measurements exceeded the > minimums specified. However, that kind of leaves a big range of what > constitutes "nominal" values. Can anybody provide what are typically > nominal values for these? Below are what I measured on my particular K3 > with respect to minimums required. > > 1. 12VDC IN connectors. Required: >50K ohms Measured: >20M ohms (out of > range) > > 2. Between R36 (test point) and ground. Required: >150 ohms > Measured: 234 ohms. > > 3. Between U12 (test point) and ground. Required: >500 ohms > Measured: 4.8K ohms. > > 4. Between U13 (test point) and ground. Required: >150 ohms > Measured: 423 ohms. > > Thanks much. Any advice appreciated. > > Walter, N0DZJ > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com >
_______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
