Thanks Don, You have eased my mind.
Fred, KC9QQ On Thu, Jan 22, 2009 at 8:18 AM, Fred Keller <[email protected]> wrote: > I am currently in second stage of assembly of the RF board. After > soldering D23, D24, D25 and D26 I noticed that D25 is not flush with the > board. It is sitting above the board by about 1/16th of an inch. I > reheated the two solder joints and try push the diode flush to the board, > but it seems as if it is being held up by some sort of burr on the lead. I > have been reluctant to use the solder wick to remove and re-install the > diode for fear that I might overheat and damage the diode. My questions > are: > > 1. Is this 1/16" gap on D25 significant if the other diodes are flush? > 2. Should I take the risk and remove and remount D25? or > 3. Should I move forward with the construction and wait to see how the > system performs before I attempt to re-mount D25. > > Fred, KC9QQ > >
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
