Tom, I am curious how you are communicating with your K3. Are you using a USB/serial converter? Make sure you don't have anything else in the chain of communication, then try it again. I had a similar problem in the past. Also, if you are use a USB converter, make sure the drivers are up to date. Feel free to contact me off the list for further q's. my call @charter.net
Best of luck, Mike N8XPQ Tom CX7TT wrote: > > After using 2.57 for several months I decided to upgrade to latest > software. Started the K3 Utility, V 1.1.6.3 and had it check the website > for upgrade. > This is from the K3 Utility log: > > 13:31:24 K3 Utility Version 1.1.6.3 > 13:34:18 Opening connection to ftp.elecraft.com > 13:34:18 Connected to Elecraft server. Please be patient, this takes a > few seconds. > 13:34:24 Copying files to C:\Documents and Settings\Owner\Application > Data\Elecraft\K3 Firmware > 13:34:31 Copied hmcu0278.hex from Elecraft > 13:34:35 Copied HDSP0198.HEX from Elecraft > 13:34:40 Copied HAUX0198.HEX from Elecraft > 13:34:43 Copied hfwnotes.rtf from Elecraft > 13:34:45 Copied K3UtilityVersionInfo.txt from Elecraft > 13:34:45 Copied 5 files from Elecraft to C:\Documents and > Settings\Owner\Application Data\Elecraft\K3 Firmware > 13:34:45 Ready > 13:37:28 K3 failed to enter MCU firmware load mode > 13:37:36 MCU programming failed. Verify file source and version. > Turn the K3 off and back on, then re-try the firmware load. > 13:37:42 Ready > 13:42:31 K3 is not responding > 13:42:31 K3 is not responding > 13:42:33 Ready > 13:43:57 K3 is not responding > 13:43:57 K3 is not responding > 13:43:59 Ready > 13:49:50 K3 is not responding > 13:49:54 K3 is not responding > > I tried turning on and off the rig, of course by having to kill the > power supply and holding the Power switch on until MCU LD > reappears...along with flashing TX led. > I am using the microKeyer II as my interface and went to the K3 port (3) > and clicked on the "disable router inquiries" before starting the > upgrade process. > I did save the previous config using the K3 utility but now the K3 is > not responding to the com port so K3 utility is essentially dead... > > Help! > Tom > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > -- View this message in context: http://n2.nabble.com/K3-Dead-MCU-Load-tp2218676p2218881.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
