wayne burdick wrote:
>
>
> I attempted to make a distinction between "operating" menu entries
> (MAIN) and "configuration/test" menu entries (CONFIG). It's possible I
> didn't get this right in some cases, in hindsight. But I have noticed
> that as the firmware and options near completion, the average operator
> needs CONFIG menu entries less often.
>
> I can move menu entries around if there's a compelling reason. So far I
> haven't seen one :)
>
>
The main thing I go into CONFIG for is to access LIN OUT. If you just use
one bit of software you ought not to need to change it once it has been set,
but some programs seem happier with a different input level than others.
-----
Julian, G4ILO. K2 #392 K3 #222.
http://www.g4ilo.com/ G4ILO's Shack http://www.ham-directory.com/ Ham
Directory http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3
--
View this message in context:
http://n2.nabble.com/Main-vs.-Config-Menus-tp2216024p2221057.html
Sent from the [K3] mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
