I neglected to check the circuit characteristics before installing the diode that is added for this mod (note to self: don't do this again).
With the diode installed, what I see with my DMM is about 1K ohms to ground (with the DMM set below diode barrier voltage) which, looking at the schematic, seems OK. If I change the DMM to check diode response, I get about 0.5 ohms in the forward direction (again OK). But I also get about 0.5 ohms in the reverse direction which isn't right (unless the the IC on the other end of this circuit has "opposite" polarity). If you have done this mod, are you seeing similar measurements?
Mike W5FTD
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
