Mike, The 0 - 9 buttons are 'quick memories' and are the same as normal memories 0 thru 9. If you have data stored in the normal memories 0-9, then tapping M>V followed by a tap of the appropriate button should retrieve the memory contents.
If you want the 0-9 buttons to act like 'band select' buttons, then set the CONFIG: MEM 0-9 menu to BAND SEL and once settings are stored for any frequency in a band, those memories will return to the last used frequency, mode, antenna selection, filter selection on that band. You can also use the 0-9 buttons to store those memories. Set up VFO A and VFO B each with their modes and other settings. Then tap V>M followed by a tap to one of the 0-9 buttons. To retrieve, tap M>V folowed by a tap to one of the keypad 0-9 buttons. The M1-M4 buttons are similar, but are PER BAND. That means you must select the band first. Then you may store or retrieve the memory contents for each of the 4 buttons. Tap V>M, then tap the M1-M4 button to store. Tap M>V followed by one of the M1-M4 button to retrieve. W0MU Mike Fatchett wrote: > Ok I read the manual and I have been unable to program the m1-m4 keys or the > 0-9 keys. I can program a normal memory just fine. > > Is there a menu setting that I am missing or did I have to do something in > the K3 utility program to get this to work? > > Mike W0MU > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
