I discovered that my cw power issue was due to a bad power supply for my Elecraft W1 wattmeter. My cw power measurement now agrees with the K3 setting. I still see a 50% higher power output in Data A mode than the K3 setting -- this is an improvement over the nearly 100% that I was seeing using previous firmware. These observations agree with what G4ILO is seeing.
> >I installed the new beta last and tested the new output power control. >I don't see any improvement in PSK31 output power using DATA A mode. I >still get nearly twice the output power than I have dialed in by the >PWR knob. In the previous firmware, the measure output power in CW >modes agreed with the PWR knob setting, but now the power output in CW >is 20-30% higher than the setting. > > >I will try to redo the transmitter gain calibration to see if this >helps. > >Steve N9SZ > >K3 #1672 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
