Hi, Ron. If you're sending with a paddle, you need to send "..--"
If you're sending with software (the KY command), you can send KY followed by an ASCII EOT character (0x04) followed by a semicolon to stop sending. The K3 Utility terminal page uses this technique. If you're sending from one of the K3's CW memories, make the last character in that memory the ..-- character, and when the memory is "played", carrier should drop. 73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Ron NA9F Sent: Tuesday, February 17, 2009 8:54 AM To: [email protected] Subject: [Elecraft] CW-to-DATA Two questions: 1st. While using the internal CW-to Data mode I notice a 4 sec idle transmit period before exiting to receive mode. Is there other way besides, sending "..--" at the end of your tx, to switch to receive? I think 4 seconds of idle state is way too much and do not really like to have to send ..-- after each transmission. 2nd. What has anyone found out about tuning in a PSK signal that may not be covered in the manual? It seems like some stations can be easily tuned fin while others are much harder. I have noticed that Digipan copies better then the K3's decode but it may be my inability to get the tune right. Ron NA9F -- View this message in context: http://n2.nabble.com/CW-to-DATA-tp2341909p2341909.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
