You can also change the menu setting to enable the SUB-RX, you will get error message when you power on. Don't worry about that. At this time you should get the audio back.
73s David , BA4RF On Fri, Apr 3, 2009 at 12:40 PM, hb9brj <[email protected]> wrote: > > > Guys, i just completed the initial test and calibration. > I hear no sound from the speaker or headphone, the rx shows no s-meter > action when i transmit a signal with an other tx. > There are no ERR-Messages. > > The radio ist equipped with the Transverter-Interface, I still have to > install the Sub-RX and KPA100. > > > Experienced the same when building my K3 in August 2008. > > It seems that the AUX-DSP board (used by Sub-RX), when installed during the > front panel assembly, blocks the entire system as long as the Sub-RX itself > is not installed. Support told me to remove the AUX-DSP board, do the > initial tests and only reinstall it before adding the Sub-RX. > > Markus > > -- > View this message in context: > http://n2.nabble.com/K3-%3A-no-sound-from-speaker%2C-no-rx-tp2578094p2578924.html > Sent from the [K3] mailing list archive at Nabble.com. > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
