I'm using FW rev MCU 3.11 / DSP 2.15, but a lot of revs back I saw the K3 reset to LP from HP when a high SWR was encountered. Only noticed this afterward [not watching the RF power meter at the time]. Had to manually set CONFIG:KPA3 back to nor to get HP capability back.
I haven't seen this since, but it might be a bug. For my part, I just thought it was operator error... 73, matt W6NIA K3 #24 On Fri, 01 May 2009 01:00:51 +0000, you wrote: >The K3 went to LP yesterday without me knowing it. I was surprised that no >one on the QCWA CW net could hear me until I finally looked at the power >meter. When CONFIG TX GN is examined, it says LP but I don't find a way to >make it go to HP. If the PA has failed the K3 didn't tell me. > >I had planned on using the K3 for the 7th Call Area party tomorrow, and I >hope some one can help this over-the-hill operator understand how to use >this radio. > >73, Jim w3cp > > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
