> Many thanks to W6NIA,NT6A,N5GE,& AB7R for advice and > suggestions, but still no success. Finally went to Elecraft > Utility, did a update and turned the radio off.
What software were you using when the K3 was put into the low power mode? If your software is using the K22 enhanced command set and sets low power using the enhanced command (PC###N where N=0) the KPA3 is disabled. The solution is to use the same software to reset power to more than 20 watts (PC0201) or use CONFIG:KAPA3 to enable high power (PA nor). Longer term, application software should avoid the enhanced K2 CAT command mode or always use the set power command with "1" as the final digit (e.g., PC0101 to set 10 watts) to avoid disabling the KPA3. 73, ... Joe, W4TV > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of W3CP > Sent: Saturday, May 02, 2009 1:24 AM > To: [email protected] > Subject: Re: [Elecraft] How do I make my K3 go to HP (100 W) > > > > Many thanks to W6NIA,NT6A,N5GE,& AB7R for advice and > suggestions, but still > no success. Finally went to Elecraft Utility, did a update > and turned the > radio off. Sometime later I turned the radio on and it was on HP! All > operation seemed normal; it could be switched from HP to LP > and then back to > HP with the PWR knob, just as it should and as it didn't when > the problem > ocurred. Sort of an unsatisfactory fix, don't know the cause > or the cure. > > 73, Jim w3cp > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
