Well I just placed the order for the SubRX today so I should be getting that cable in the box. Here's hoping that all goes well with the install as I won't have much time to get replacement parts from Elecraft before FD if there are any issues.
On Mon, 2009-06-15 at 08:52 -0700, Bill W4ZV wrote: > > > Brett Howard wrote: > > > > I think for most normal operations I want to use the KAT3 port for the > > Aux antenna jack for my KRX3 but I'd like to have the option of using > > the AUX RF port without too much hassle. Does anyone see any reason why > > one would have any problems mounting the BNC jack and routing it and the > > other TMP cable (connected to the KAT3) together then just tape off the > > one that I'm not using and let it float in there. I could even throw a > > connector with a short on the AUX RF connector when its not in use to > > make sure and completely ground out the floating cable (not sure that > > would really be needed but couldn't hurt right?) > > > > This is actually a good idea for anyone considering later adding the KRX3 > when first building your initial K3. It's much easier to install and route > the AUX RF connector and cable initially, even if you don't install the > KRX3. I believe the only caution is to secure the TMP connector so that the > shield cannot touch any active components. I taped my TMP cable to the > outer sheet metal enclosure for the KPA3. > > I don't recall the part number for the AUX RF TMP cable assembly normally > supplied with the KRX3 but Elecraft will know what you mean if you place an > order for one with your initial K3 order. > > 73, Bill > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
