Tried it again using my XG2 as a signal source, and it's working OK. Gremlins at work !
73 Stewart G3RXQ On Sat, 15 Aug 2009 11:03:23 +0100, Stewart wrote: > As you say Brett ... Interesting. > I will try it again, and look for any new Menu settings that may have crept > in unnoticed. > This was on SSB, a mode which I use almost 100% of the time. > > 73 > Stewart G3RXQ > On Sat, 15 Aug 2009 02:24:57 -0700, Brett Howard wrote: >> Interesting.. Mine seems to be working as it did before. I just tied >> it on a few AM stations near 40. Got in the area in LSB got it setup >> with the carrier in my window hit the button and poof gone. >> >> I then found another tone that seemed to be drifting back and forth a >> little bit and hit the auto notch on that. It seemed to notch it but >> was following it a bit slowly so it was just off of it every so often >> but it was updating and keeping things quieter. >> >> I also QSYed quickly when the notch was doing its thing and you hear the >> tone come back for a short bit then you hear the filter slide over and >> keep the carrier covered up. >> >> Are you sure you're in a mode that supports the auto notch? Its not >> supported in DATA or CW. >> >> ~Brett (KC7OTG) >> >> >> On Sat, 2009-08-15 at 10:07 +0100, Stewart wrote: >>> am finding the same here - AGH ! >>> >>> The Manual notch is fine, however, although there is a slight >>> notching action in Auto it is virtually useless. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
