Good afternoon, Folks. First off, I have NO COMPLAINTS WHATSOEVER on my K3/100 - Kit [S/N 2802]! I have five Filters installed [the bandwidths of which I won't mention fearing massive retribution - but personally they suite me just fine as I'm a CW operator only!], the Ant Tuner and the 1ppm Ref. Oscillator. A super FB/fantastic rig! I do have a question and I feel sure the answer will be "Operator Error"! Here goes: EVERY time I load a new version of Firmware to my rig or save the "current configuration" using the current version of the Utility, I have to do them both TWICE! On the Firmware updating, all goes well with the FPF Load [every time] but when it comes to the DSP Load, it gets to about the 30% mark and locks up [every time]. I have to back out of the loading and start again and then it loads OK [every time] . This malfunction freezes up the Utility stating afterwards that the Serial Port is closed and can't be opened because it is being used by another program. [ ? ] It takes several moments for the Utility to recover. Similar happenings when I "Save the Current Configuration". It crashes my computer. I have to re-boot and then it saves OK. That is if the Serial Port has recovered. I using the current version of the Utility for Windows XP. I using a KEYSPAN USB to Serial Adapter. Thanks for letting an old man rant & rave! Best 73. Jim......... WA4NTM K1-4 - S/N 2580 K3 - S/N 2802 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
