Just how much power are you running? If going from 100 to 110 makes a 500 watt difference in the output, then you must be putting out 5000 watts with 100 in, assuming the amplifier is linear.
Somehow I suspect this isn't the situation... Seriously, in general amplifiers need about 50 watts input to get full legal output. That's about a 15dB max gain as set by the FCC rules if I remember correctly. If you need to put much more than that in, then you either have a lot of loss in the input coupling network (this is intentional on some designs), or the efficiency of the finals is really bad (old tubes?). Your strategy of getting it checked out is a good one. On Sep 20, 2009, at 8:14 PM, -.-. --.-N3TU -.-. --.- wrote: > > I'm not causing distortion and stations say it sounds clean on the > air. I > think I am going to get the amp looked over. Thanks for the info. > -- > View this message in context: > http://n2.nabble.com/Will-I-Lose-the-120-Watt-Max-If-I-update-The-Software-tp3682736p3682879.html > Sent from the [K3] mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html -Jack Brindle, W6FB ======================================================================= ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
