Hi Tom, This is covered in the KPA3 manual:
http://www.elecraft.com/manual/KPA3_Option_Installation_Rev_E.pdf page 16. GL, ~Iain / N6ML On Wed, Oct 21, 2009 at 11:06 AM, <[email protected]> wrote: > I am putting my K3 back together after having to replace the original > P67B connectors with gold pins after rtty contest smoked the pins last > month. Tnx to Gary S for working with me long distance to figure out the > problem. My K3 , #250 had plated pins vs the newer gold pins...this is a > factory assembled K3 so I was very leery of diving into the guts of the > rig. thankfully Gary walked me thru it and now the final step of putting > lids back on, etc, I am hooking up the fans. I dont remember which goes > to which, or if it even matters...a short lead, red/blue seems to fit > the outboard pins and the longer lead, black/red seem to fit the inboard > male connectors. Before I give it the smoke test, do I need to correct this? > Finally, on the power leads to the 20A fuse...I have outmost going to > top connector and innermost going to bottom connector of circuit > breaker. Not sure if it makes a difference but at this point, just b4 > ssb contest, dont want to make bonehead mistake. > Tnx and CU in test > Tom > CX7TT > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
