Yes ... I can hear them prominently when using the WIDTH control as well. I tried both AF-HI and AF-LO, as well as AGC-F and AGC-S, with the same result. No AFX, no NB, no NR or anything like that, and it happens in both CW and SSB modes as long as there is a tone present in the background (CW, PSK, tuner-upper, etc). It's more pronounced with wider bandwidths, of course, since the noise clicks are sharp and have lots of high frequency components.
I'm using FW 3.52. 73, Dave AB7E Doug Alspaugh wrote: > Hi Tom, > > Yes, after saying I did not hear them I just this moment did hear them in my > out board speaker. Looks like a CW sig needs to be present before I hear > them, but they are very prominent > > > 73 Doug N3QW > ----- Original Message ----- > From: "tom_k1tl" <[email protected]> > To: "Doug Alspaugh" <[email protected]> > Sent: Sunday, November 01, 2009 9:17 AM > Subject: RE: [Elecraft] [K3] Noise Clicks...still! > > > >> Hi Doug, >> >> Seems that I did not have this b4 the 3.44fw update and since then I have >> been hearing the "clix" in the headset...almost sounds like "key clix." >> >> It might also be that I have a bad decoder pot as one signal did change >> freq >> while I was tuning thru the steps. It did not show up on the freq display >> of >> the K3 tho. >> >> I sure hope that it is not the encoder piece as the fp is a pain in the >> a** >> to put back together due to the LED's not lining up properly at times. I >> have no problem doing the pc work as I am all equipped here in the shack >> for >> that kind of stuff. >> >> 73 >> Tom/k1tl... >> >> -----Original Message----- >> From: Doug Alspaugh [mailto:[email protected]] >> Sent: Sunday, November 01, 2009 9:02 AM >> To: tom_k1tl; [email protected] >> Subject: Re: [Elecraft] [K3] Noise Clicks...still! >> >> >> Could you just be hearing the width steps. That is all I hear here. >> >> >> 73 Doug N3QW >> >> >> ----- Original Message ----- >> From: "tom_k1tl" <[email protected]> >> To: <[email protected]> >> Sent: Sunday, November 01, 2009 8:45 AM >> Subject: [Elecraft] [K3] Noise Clicks...still! >> >> >> >>> Hi Gang, >>> >>> Had problem with "noise clicks" while using the width control before this >>> latest fw upgrade. I thought that this was supposed to be addressed with >>> the >>> latest fw. I have 3.52 installed and still have clicks in the headphones >>> when adjusting the width control. I thought it might be caused by some >>> of >>> the stations that were loud, due to the close proximity of the signals >>> but >>> did not have this before 3.44 fw. >>> >>> Has anybody else have similar problems with this "artifact"? >>> >>> 73 >>> Tom/k1tl... >>> >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:[email protected] >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >>> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
