> I've always found that if you have a loud CW signal present, and you start > narrowing down the passband width just adjacent to them, you get clicks.. > That's just codes little way of knocking at the door of the filter... Until > you get narrow enough, or far enough away from their transmission your going > to hear them. If the signal is an S4 of S5 you probably wont here them > nearly as close as say someone at S9 or 20 over S9. That's what I've found > anyhow. This has ALWAYS been the case. Perhaps it has something to do with > the fact I have Filters in my rig, and not just depending on the DSP???
In general, be sure you have FIR rather than IIR filters selected. CONFIG:FLx GN and tap "7" until you see the message "IIR OFF" You can use most any of the CONFIG:FL menus for this. The click or "pop" as you go between a width of 0.15 and 0.10 is normal. 73, Lyle KK7P ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
