Hi Joe, Thanks for the reply. I don't think it's much of an issue either. Only reason I asked is I recently replaced front panels. I didn't know if I screwed something up during the transplant. I do not recall hearing the same ticking/pulse noise with the previous hardware. Good to know I'm in the clear.
73 de James K2QI -----Original Message----- From: Joe Planisky [mailto:[email protected]] Sent: Monday, December 07, 2009 8:26 PM To: James Sarte Cc: Elecraft Subject: Re: [Elecraft] K3: Shift/Width encoder pulse noise? Hi James, As far as the noise when you turn shift/width, yes, I hear it too. I assume it's the result of changing the DSP filter parameters. If done while it's processing a strong signal it seems there's bound to be some artifacts. I don't know if anything can be done to quiet them. I personally don't consider it a problem, but others might object to it. As for the shift/width not altering the sub-RX settings unless you're in B-set, I think that's normal unless you're in diversity mode. As for the different feel of the encoders, I can't comment. Haven't had to replace mine. 73 -- Joe KB8AP ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
