On Sat, Dec 12, 2009 at 2:20 AM, Mike Weir <[email protected]> wrote:
>
> Good evening all
> I am about to set the K3 up using the K3 utility program. To configure the
> filters of which I have the Stock 2.7 khz 5 pole crystal filter, inrad 500
> 400 and 250 filters. Does the utility take you through all the steps that are
> in the manual on page 46 (bandwidth, frequency offset and transmit crystal
> selection) or do I have to go back and forth from the k3 utility to the
> manual for complete filter setup?
Not really sure what you mean by "go back and forth...", but the K3
Utility presents a form where you specify all of the filter parameters
for the filters in either the main or sub receiver, then submit it to
the K3. It's quite straightforward.
~Iain / N6ML
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
