The K3 Utility filter configuration dialog helps you to completely set up filter bandwidth, offset, gain, rx filter select by mode, and Tx filter select by mode. There is a screen shot in K3 Utility Help that shows this.
Dick, K6KR Sent from my iPhone On Dec 11, 2009, at 4:20 PM, Mike Weir <[email protected]> wrote: > > Good evening all > I am about to set the K3 up using the K3 utility program. To > configure the filters of which I have the Stock 2.7 khz 5 pole > crystal filter, inrad 500 400 and 250 filters. Does the utility take > you through all the steps that are in the manual on page 46 > (bandwidth, frequency offset and transmit crystal selection) or do I > have to go back and forth from the k3 utility to the manual for > complete filter setup? > Mike > VE3WDM > > _________________________________________________________________ > Windows Live: Make it easier for your friends to see what you’re up > to on Facebook. > http://go.microsoft.com/?linkid=9691816 > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
