Dave - No joy. I did as the Utility Help said, but after the 10second start it goes back to the red TX led flashing and the screen is dark.
I took out the KIO3 thinking that something was in transmit mode. Again, no joy, same symptoms. I can't even get a screen display. I'm holding off taking out the KPA3 to see if there are other suggestions. I'd like to avoid that. This is very frustrating, but I appreciate your suggestion.... 73 de K1ESE John Dave G4AON wrote: > John in the K3 Utility Help file it explains what to do, it's under > troubleshooting - Force K3 into firmware load required mode > > Hope that fixes the problem... > > 73 Dave, G4AON > K3/100 #80 (f/w 3.68) > ----------------------------- > > I attempted to update my K3 to version 3.68 and now my K3 no longer works. > > It was working fine. I updated to version 3.67 yesterday. I tuned the > radio on just now. It was working fine. I downloaded and extracted > version 3.68. I opened the K3 Utility. The utility read the K3's > firmware and saw that the 3.67 MCU file was newer. I clicked on "Send > all new firmware to K3". > > The K3 screen said something like MD D. The utility said something like > D didn't echo, remove power. I couldn't turn the K3 off, so I removed > power. I reconnected power and turned on the K3. Now the red TX led > flashes slowly and I can't turn off the K3 without removing power. > > Now what??? > > 73 de K1ESE > John > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
