On Wed, 23 Dec 2009 03:30:27 -0800 (PST), Bill W4ZV wrote: > > > Stewart Baker wrote: >> >> >> As I wish to keep maximum flexibility of antenna switching I do >> not want to use the AUX BNC for the Sub RX as it stops me from >> easily using either the main antenna or loop as Sub RX input. I >> don't want to be reconfiguring the K3 hardware as my needs change. >> > Thanks for your reply Bill.
> I may not fully understand what you're doing but it sounds like you only > transmit through the doublet. If you feed the loop into AUX RF, and doublet > to ANT1, you can set Sub RX to receive on either the doublet (MAIN in the > BSET menu) or loop (AUX in the BSET menu). When BSET is selected I can switch between MAIN (Ant 1) and AUX (Ant 2) by pressing the ANT switch. AUX is allocated to Ant 2. This means I am still able to TX thru the loop pre-amp if I am not careful. Also I cannot select RX Ant input to the Sub RX when in BSET. That switching path must not exist. 73 Stewart G3RXQ This will ensure that you never > transmit through the loop. When in Diversity, it's very easy to switch > between Sub RX antennas by HOLDing RX ANT which toggles the two choices. > > 73, Bill ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
