Rich, If you will look at the photo #2 at the lower right quadrant of page 32- You will see that what you are to cut are the bits of the pins that stick out of the back of the small board attached to the encoder. Do this before you install the encoder. This is done to prevent these from shorting out to the DSP board after assembly. Trim them nice and flush to the board.
73 and have fun, Bruce N1RX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
