Wayne & Gary, Thanks for the support off the list. After I set PA TEMP to "R ONLY" instead of "T AND R", the problem stopped. I don't know the reason why. But anyway it seems usable with this setting for the time being.
Jaakko, Please try this setting on your K3 too. TU & 73 Atsu, JE1TRV ----- Original Message ----- From: "Wayne Burdick" <[email protected]> To: <[email protected]> Cc: <[email protected]> Sent: Wednesday, January 13, 2010 1:36 AM Subject: Re: [Elecraft] K3 HI-TEMP ALARM > We're looking into this. > > 73, > Wayne > N6KR > > On Jan 11, 2010, at 7:20 PM, [email protected] wrote: > >> Hi folks! >> Thank you for suggestions. >> >> In my previous post, I forgot to say that my K3 works without hi-temp >> alarm after warming up (about 30min or so without transmit just >> receiving >> status). >> >> So, it's just the same with Jaako's case. >> My shack temp was around 15C these days. >> >> hmmm... >> >> Atsu, JE1TRV >> >>> Hi >>> >>> I have same problem, when shack temperature is below 17 degrees >>> Celcius >>> >>> When PA Temp is higher than 25 degrees C then power is OK. >>> >>> Jaakko OH1MA / K3 ser. 2952 >>> >>> >>> Hi Elecrafters! >>> >>> I have problem on my K3/100 (S/N3050, factory assembled). >>> When I transmit more than 12W(means hi power amp on) >>> within about 30min after mains power on, HI-TEMP alarm >>> occur and equipment is forced to set 5W. >>> >>> No problem at all when hi-power amp is through ( Po<12W ). >>> >>> Any idea? >>> Thanks in advance >>> 73, Atsu JE1TRV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
