Bill, That is the menu setting for setting the carrier balance potentiometer (SSBa=bal). While it could work for some purposes, I for one would not trust it for a good evaluation of the transmitted audio. An external receiver will not only give you the sound of the actual transmitted audio, but can also tell you that the passband of the SSB FL1 filter has been properly positioned for your particular voice, and can also tell you if you have done the dial calibration correctly - If you hear a good quality received signal at the same frequency the K2 is set to, then both the K2 dial calibration and the position of the SSB FL1 filter passband is correct. Other aspects of the transmitted could also be evaluated, such as tailoring the audio response of the mic and adjusting the compression, but it may be difficult to evaluate that while you are speaking due to the effects of bone conduction. It would be best to record the received signal and then play it back.
I would only use the carrier balance menu parameter to make a quick judgement about the compression setting selected. 73, Don W3FPR Bill K9YEQ wrote: > Don, > > I thought one could listed to audio from the mic using a front panel switch. > It has been a few years since I did this. I need to do it again so before I > try it again on a new mic, what is it that one is monitoring when using the > function? > > > 73, > > Bill > K9YEQ > > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Don Wilhelm > Sent: Tuesday, January 19, 2010 12:14 PM > To: n0jrn > Cc: Elecraft > Subject: Re: [Elecraft] Heil HC-5 & K2 > > Jerry, > > The K2 has no provisions for monitoring the transmitted audio. A > separate receiver works well. I keep one at the workbench specificall > so I can check the transmitted SSB signal after I align the filters on a > K2 - that is about the only use my Yaesu FT-900 sees anymore. > > 73, > Don W3FPR > > n0jrn wrote: > >> Along this line ! >> >> Does the K2 have a monitor circuit built in or does one need a separate >> receiver to check clarity ??? >> >> I find no reference to monitoring the transmitting voice in the K2 manual >> but wanted ask anyway. >> >> >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
