Hello from UK, I have a problem with my K2 s/no 2390,a long story but the short version is that it was ok when I aquired it 12 months ago but could not get 40 mtrs band,after afew emails from our helpful friends I found that D19 in the sec menu was not switched on ,I did this and all bands were working okon receive. I then decided to put rear bott panel back on along with the pa transistors checking for shorts etc, (taken off previous to check for dry joints) all other modules were re installed ie k60 xv and 160mtr units .On switching K2 back on nothing at all but af noise ,no signals at all on any of the bands ,display and all controls seem to be working correctly,Ithought I may have had a dry joint appear somewhere so rear panel off again to look could see nothing .I checked and resoldered all pcb joints on the main board and still dead as a do do!!(not hi) Thinking would a reset on the K2 help? Can anybody out there help as don't know what to do next will even consider sending to some one who can fix or help local in the UK m/cr,lancs area, and as a last resort to the USA ,or Elecraft if it requires it. Tnx for reading,Frank -- View this message in context: http://n2.nabble.com/K2-help-Fault-pulling-my-hair-out-tp4449880p4449880.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
