-------------------------------------------------- From: <[email protected]> Sent: Wednesday, March 03, 2010 11:47 AM To: <[email protected]> Subject: [Elecraft] K-3: RTTY Dual Passband Question
> Question: If you don't normally use Dual Passband while in RTTY > Mode, then > is it true that you need to be careful where the "SHIFT" > control is set? ---------------------------------------------- Yes, you need to set SHIFT such that the MMTTY FFT display is symmetrical about the mark and space frequencies (the vertical yellow lines on the FFT display). Set WIDTH as low as possible without attenuating the mark and space frequencies. Set K3 shift control to fine granularity (config/pb ctrl/shift=.01) In MMTTY, turn off NET, AFC, ATC. Make sure MMTTY MARK frequency matches K3 PITCH. Dave Hachadorian, K6LL Yuma, AZ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
