Thanks, Ok, so it is feature!
Yes I have adjust MIC and CMP just like manual, not effect. So there is no solution to problem. juha 2010/3/28 Dave, G4AON <[email protected]> > Juha this "problem" is an old one. Some time back the K3 had poor ALC which > allowed for overshoot on peaks, the firmware was altered to soften the ALC > control with the results you (and the rest of us) experience. The power can > slowly increase over the first few seconds on SSB, the effect is less if you > "TUNE" first via the front panel button. Also, have you checked that you are > driving the ALC meter reasonably well, as per the manual? > > For comparison, my TS-480SAT is also quite soft on ALC control with the > peak power seeming to vary from one moment to the next. With some previous > radios I recall seeing the peaks on an oscilloscope looking like a trimmed > hedge, which is liable to create excessive IMD. > > I use an LP-100 peak reading power meter and the K3 is similar in it's > peaks compared to my TS-480 with the same linear (Acom 1000). I don't think > it's anything to worry about. > > 73 Dave, G4AON > K3/100 #80 f/w 3.79 > ----------------------------- > > > I have K3 #2100. On CW power is very stable, but not on SSB. There is some > change on output power, it is not constant. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
