John, Have you tried Hamlib to see if you are able to establish a connection to your rig?
If Hamlib worked and RigCat didn't that could narrow down your field of possibilities. Also, does the Elecraft utility communicate with your rig using this configuration? 73, Dave. K6DCH Sent from my iPhone On Mar 31, 2010, at 12:25 PM, John Ragle <[email protected]> wrote: > I am: > > Using WIN 7 Ultimate. > > Using Elecraft K3/100 set to "Data A" or to "USB." RS232 params set to > 19200 + 1 stop. > Using E'craft USB to RS232 adapter, which loads driver and selects > COM13. Device manager shows COM13/19200/1 stop. > > Using SignaLink USB with E'craft cable to rear connections. > > Using either fldigi 3.12.5 or 3.20.b9...problem is the same with > either. > > Using RigCat with K3.xml, 19200 + 1 stop on Com 13. > > > Everything appears to be normal...receive OK, transmit OK via > SignaLink, > TX power levels correct, waterfall appears normal. > > Problem: NO CAT Control...no rig control (frequency) via fldigi. > (Should > be coming in on the RS232 line. Disconnecting the RS232 line has no > effect.) > > On bringing up fldigi it throws an error "E: rigCAT_getfreq: Hexout > failed" & in addition the "QSY" button on the bottom toolbar is greyed > out. Both these are clearly related to the failure to communicate > across > the RS232 line. > > Any suggestions? > > John Ragle -- W1ZI > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
