Foxjazz, (Eric may chastise me for this post because he, not I, is the list "policeman", but I will do it anyway).
OK, I have learned from another ham here on the reflector that you do have a call and I looked up your name on QRZ.com. N0XDB - Joseph T. Dickerson III. Would you please use it on your subsequent emails to the reflector? It will make you seem more like a human and a ham as opposed to some troll or someone who wants to remain anonymous. In addition, I notice that you start your emails with "Hello Elecraft,". We here on the Elecraft reflector are *not* Elecraft. We are a group of Elecraft owners, or prospective Elecraft owners. Many of us are willing to help you as best we can, but we are certainly not the official Elecraft support organization. If you wish to reach Elecraft support, the proper email is [email protected], and if you wish to reach sales, it is [email protected]. It is a fact that some (but not the majority) of the Elecraft employees (and Eric and Wayne as owners) often monitor this reflector, but there is no guarantee of that. If your intent is to reach "the real Elecraft", you should send email direct rather than to this reflector. Yes, I *do* repair work for Elecraft, and to that extent, I am an Elecraft employee, but I am paid only for the actual repair work I do. Any support I provide here on this reflector is not a task for which I have been "Elecraft authorized" or for which I receive compensation, and my comments are not official. I volunteer my time and comments here only as one ham helping out another ham - there is nothing "Elecraft Official" in my postings here on the reflector, they reflect only my own views and experiences. I have had extensive experience with many of the Elecraft products, and am willing to share whatever knowledge I have with other hams in an effort to help them with whatever problem they are having. If I do not feel I can help, I normally will not post a reply. 73, Don W3FPR Foxjazz wrote: > Hello Elecraft, > > Hello Don, > > > I had the pll working before I did phase 3 and put the ssb board in. > > It was working great, now it isn't. I thought I would run a quick > voltage test before continuing. Now the pll freq is 0.000 > > I reviewed the test results and re-tinned T5 just to ensure good > conductivity. > > When I ran the resistance checks the base resistence of Q6 was at > 372 ohms not 100-140 as the book says. > > the unit turns on draws 0.24 amps > > 0.22 without the ssb board in. > > Why would the pll circuit just quit working, would q20 have anything > to do with it? > > The voltages at q18 are a bit high. > > > > > > I had the pll vol > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
