Hi Doug, Thank you for your reply !
As answered to Richard, i've done the bad choice when ordering a P3! My "bad" idea was to connect him to a "future" KRX3 !! Fortunately it was not too late to stop my order ! But for the P3... My best 73, Rudolf, HB9ARI Doug Joyce wrote: > Rudolf: The IF output from the K3 is from the main receiver not the > sub receiver. If you check back in the archives, there are some > articles relating to getting an IF sample from the Sub RX. > > 73, Doug VE3MV > K3/100 s/n 2432 > > > ----- Original Message ----- From: "hb9ari" <[email protected]> > To: "Elecraft-forum" <[email protected]> > Sent: Tuesday, May 25, 2010 5:52 AM > Subject: [Elecraft] K3 Sub-receiver use > > >> Hello, >> >> Before to order a sub-receiver for my K3 (#1212), >> i would know if the primary use i've envisaged is possible: >> >> RX/TX on main receiver on 20m for example, with >> output power between 5 and 75W (JT65A mainly). >> Sometimes, the auto-tuner in the K3 is used. >> >> RX on sub-receiver for 6m on a separated antenna, >> (Preampli 6m Elecraft ON or OFF) and IF output to >> the (ordered ) P3 for band monitoring. >> >> Thank you for information, because i'm not >> clear with hardware and firmware version >> necessary for this "dual" band use. >> >> My best 73, >> Rudolf, HB9ARI >> >> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
