That characteristic has been discussed here Roger. The driver generates spurious signals between 8 and 13 watts, so the software makes the level skip these powers until the 100 watt final kicks in at 13 W. Willis 'Cookie' Cooke K5EWJ
________________________________ From: Roger Dixon <[email protected]> To: [email protected] Sent: Fri, June 11, 2010 9:59:44 AM Subject: [Elecraft] Power control on 50MHz On all other bands, increasing the power level goes in 0.1W steps up 12watts and then in one watt steps above this. I'm sure this used to happen on 50MHz as well. However, now the power increases in 0.1W steps to 8 watts and then jumps to 13W before increasing in 1W steps. So I can't set an output level between 8 and 13 watts, which is just what I need for the amplifier!!!! Any ideas as to what I can have done to achieve this "feature" ? TIA Roger - G4BVY ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
