Andy, I use DXLab's Commander, its rig control module, with its user-defined sequences to do this. They are DXLab's equivalent of K3 macros. I have one to switch between the two mic inputs and set the TXEQ for each.
My setup has a PR781 on the front input and a Heil Proset Plus on the rear. I have no EQ on the Proset and quite a bit on the PR781. If you use DXLab I can send you the text file. Jim N7US -----Original Message----- You might be able to use a pair of command macros to set the gain and select front or rear microphone. This isn't quite what you asked for, but one of the motivations for offering command macros was to allow you to do something like this. Dick, K6KR Sent from my iPhone On Jun 20, 2010, at 7:54 PM, Andy Wood <vk...@woodtech.net.au> wrote: > > It would be nice to be able to independently select mic gain for > front or > rear panel input. Currently, changing one also changes the other. It > would > be nice to be able to set, say, rear panel input to low gain (rP.L) > and > front panel input to high gain (FP.H) independently. I find the > computer-type headset with electret microphone I use on the rear > panel (bias > turned on) has plenty of gain and only requires the low mic gain > setting. > However, using a dynamic hand mic on the front panel (bias turned off) > requires gain set to high. > > I know it is only a small issue but it would be nice to have it > added to the > "To Do" list, if not already there. > > Andy VK4KY ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
