As far as I'm concerned, all the audio is weak on the K3. Using the same speaker, the little IC7000 blows the K3 off the desk. Maybe it's got something to do with current drain. The Icom does use considerable more power in receive mode and runs pretty hot. The K3's audio is quiet adequate but just not very loud.
Steve N4LQ ----- Original Message ----- From: "Tom W8JI" <[email protected]> To: <[email protected]>; <[email protected]> Sent: Sunday, June 27, 2010 9:16 AM Subject: Re: [Elecraft] Low headphone audio level >>> We sort of got sidetracked from the original posters remarks. It's about >>> low >>> headphone level on the K3. If the level were a bit higher there would be >>> no >>> need to plug the headphones into the speaker jack. Similarly each pair >>> of >>> headphones you grab seems to have a different level. I have 3 different >>> headphones and don't intend to buy a forth. Naturally the one that is >>> the >>> most comfortable is also the one with the lowest level. And I understand >>> that most people don't seem to have this problem. It might be better >>> hearing >>> or better headphones. > > A good audio line with lots of volume headroom is everything. I can't > imagine spending so much time on everything else in the station and then > not > spending any time on something used and changed all the time like the > audio > output lines. > > I have never liked nor used the headphone jacks in anything from my > boatanchors up through my FT1000's of all flavors and the K3. I've never > found them suitable or flexible enough for my tastes. > > I always run the speaker line out to a switching system, and I terminate > that line in a load safe for the radio. Then I bridge off that line with > either a good big speaker and audio amp, or headphones. > > I have virtually no problems at all with any headphone bridging across the > speaker output lines of any radio, and I can bridge multiple headsets at > once. > > The toughest thing for me is to get guest ops to stop using the headphone > jacks on receivers and transceivers, and to use the desk mounted jacks. > > http://www.w8ji.com/cables_and_wiring.htm > > I have to finish that page some day. :-) > > 73 Tom > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
