Turned out to be that I had the graph in dot mode.... Thanks
Don W4DHH --- On Thu, 7/1/10, Don Wilhelm <[email protected]> wrote: From: Don Wilhelm <[email protected]> Subject: Re: [Elecraft] K2 S-Meter LED Question (Alignment and Test Part II) To: "Don Herring" <[email protected]> Cc: [email protected] Date: Thursday, July 1, 2010, 5:05 PM Don, I would suggest you first look for a solder bridge in the vicinity of FP DS2 (the LED array) pin 20 and/or U4 pin17. There are via holes on the board between those location which are also potential places for solder bridges. If you find nothing in that search, then the most likely problem is that U4 has a bad output at pin 17. The 6B595 IC is subject to static damage, and may have been zapped when it was mounted if good anti-static procedures were not followed. 73, Don W3FPR Don Herring wrote: > > However, during all of this, the rightmost LED on the S-Meter is constantly > lit. Any clues as to what may be causing this? > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
