Ok not sure if I am understanding this wrong or not... But I've configured my M1-M4 as follows:
M1 = 14.0 - 14.15 - CW mode - width 350Hz M2 = 14.15 - 14.35 - SSB mode - width 1.5K w/ a shift of .95 M3 = 14.03 - 0.000 - Data Mode (FSK D) - width 500Hz Dual PB M4 = 14.03 - 14.06 - Data Mode (PSK D) - width 1.5Khz I was then able to recall these just fine... However as soon as I tapped HI/WIDTH twice to view the width it would then update the passband icon and show the BW to be 500Hz. Then subsequent recallings of M4 recall the memory with a 500Hz BW. Does seem like something is slightly amiss there... ~Brett (N7MG) On Sun, Jul 4, 2010 at 3:04 PM, <[email protected]> wrote: > > > > > ________________________________ > > Perhaps someone can clarify / correct my use of the per-band quick > memories. I'm using M1 to M4 to save sub-band frequencies and filter > positions with BW settings in each of the bands 160 thru 10 and having a > problem. > > Installed roofing filters are 2.8, 1.8, 1.0, 400 & 250. Firmware is 4.03 / > 2.60. > > For example on 20 Meters if I save 14,010 and BW of 450 using FL4 with V>M, > M1 - I can recall it correctly with M>V, M1. If I save 14,195 and BW of 2.1 > using FL1 with V>M, M3 - I can recall it correctly with M>V, M3. > > The problem is with two data modes memory settings on 20M at M2 & M4. If I > save 14,080 and BW of 450 (and dual passband) using FL4 (for RTTY) - that > saves and recalls correctly to / from M2. However, if I save 14070 and BW > of 3KHz (for PSK) using FL1 and save it to M4, then go to one of M1, M2 or > M3 freq BW set and then try to recall M4 it comes up at the correct > frequency but the filter BW is now back to 450 Hz using FL3 (the setting I > used for M2). (The filter graphic seems to be correct but the actual filter > is not as previously set.) It seems that there is only one allowed set of > BW and Filter setting for the two Data modes. (I'm using FSK-D for RTTY and > PSK-D for PSK). > > Can anyone offer an explanation or correction of what what I'm doing wrong? > Or is this a limitation of what can be saved in the memory positions M1 - > M4? > > The manual isn't really too clear on this level of detail. > > Thanks & 73 > > Doug VE3MV > K3/100 s/n 2432 > > > > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
